Treatment of joints in bolt-connected stone slabs

Jun 17, 2026|

Before applying stone sealant, compatibility and stain resistance tests must be conducted. Only sealants that pass these tests can be used. Stone joint sealing is divided into open-joint and sealed types. The appropriate type should be chosen based on the design and regional characteristics.

 

Open-joint sealing involves adding a water-retaining plate to the inside of the stone joint to prevent rainwater from splashing in, effectively solving the rain protection problem. Its advantage is improved aesthetics of the exterior wall finish. Its disadvantage is that it is not suitable for stone curtain wall projects with thermal performance requirements, limiting its applicability.

 

Sealed sealing involves injecting sealant into the stone slab joints. Its advantage is a wider range of applicability, particularly beneficial for buildings with thermal performance requirements. Its disadvantage is that silicone sealant is prone to yellowing, deterioration, and dust contamination, affecting the aesthetics of the exterior wall finish.

 

To ensure bonding quality, clean the surface of the stone slab joints, removing dust, water, oil, and other contaminants, and ensure the joints are clean and dry before applying the sealant.

32

To ensure the quality of the sealant application, use a scraper with a protruding tip to fill the joints with foam rods before applying the sealant. The diameter of the foam rods should be slightly larger than the width of the joint.

 

To ensure the cleanliness of the stone surface, apply masking tape along both sides of the joint before applying the sealant.

 

Use a special silicone sealant for stone slabs. The application temperature should be within the range of 5–40 degrees Celsius. Apply the sealant as continuously as possible, ensuring the joint is even, dense, and full, without air bubbles. If sealant accidentally gets on the wall, remove it immediately and clean any excess sealant with a cleaning agent. The thickness of the adhesive should generally be half the joint width, and no less than 4mm, but not more than the joint width. If the adhesive is too thick, it is prone to breakage and cracking under stress, causing sealing and leakage prevention failure.

 

After applying the adhesive, before the surface cures, use a scraper to smooth the joint into a concave shape. The adhesive surface should be smooth and rounded, without drips or wrinkles. Immediately after finishing the joint, remove the masking tape from both sides. Applying the adhesive should be avoided in rainy or windy weather.

 

After the adhesive application is complete, use a clean cotton or lint-free white cloth dampened with solvent to clean the stone surface on both sides of the joint. Do not immerse the cloth inside the joint. The solvent should be a specialized cleaning agent or oxalic acid. Take care to protect the completed work surface.

Send Inquiry